Fiat 500 Replacement Key Fob

It might be time to change the battery if the 500 remote key fob isn't working. However, if you replace the battery but it doesn't work, then the problem may be elsewhere.

United Locksmith specializes in the creation of new keys for classic cars. We have all the necessary tools and parts for this type of service.

Dead Coin Battery

A dead battery is the most common reason for your Fiat 500 keyfob not locking or unlocking the doors. The key fob comes with an in-built battery that is prone to draining quickly if it is not utilized frequently enough. If your remote has started to show signs of loss of range or stopped functioning and the battery is not working, it could be dead.

Metal clips hold the battery in place in the key fob. If the clips aren't tight, they can create contact issues that prevent the remote from receiving power. By using a small flathead screwdriver, pry the retaining clip outwards to remove the battery and replace it with a new one. Be sure to use an identical replacement battery type of voltage, size and specifications as the original battery.

The key fob could also become corroded or damaged by exposure to water. Even a brief bath in soapy water can cause damage to the electronic chip inside. It is recommended to keep your key fob in a dry area.

Water Damage

If your key fob isn't operating properly, it could be caused by water damage. The rubber seals on key fobs prevent them from being damaged by a light splash or drizzle of water. However, it is important to keep the keys out of the washing machine, ocean, and pool.

The key fob is equipped with an electronic chip inside it that transmits a signal car's immobilizer system. This is what allows your 500 to lock or start, but if the chip gets wet, it's unable to longer function.

You can try cleaning the inside of your key fob's electronics using isopropyl alcohol or an electronic cleaner to see if they are still good. It is best to replace the key fob if it's submerged in salt water, rather than trying to fix it yourself.

A replacement fob could cost you a bit but it's far less expensive than paying to have your Fiat 500 towed to a dealership and repaired there! You can also do it yourself by following some simple steps. Just ensure you have the right battery type before you attempt to open your key fob. This task is much simpler than it appears and there are step-by-step instructions on the internet for nearly any car key fob.

Faulty Chip

The chip in the key fob communicates with the car's immobiliser unit to make sure your car is only capable of starting when the correct key is inserted. If the chip is damaged, or corrupted in any way your car will not start.

Water damage or a dead cell phone battery are among the most frequent causes of defective chips. It is best to delegate the work to a professional locksmith, who will be able to replace the chip quickly and at reasonable cost.

If your key fob stops functioning after exposure to clean tap water or rain, take out the battery and clean the electronic component with a paper towel to ensure it's completely dry before putting it back into. If the key fob still does not work it's likely to be an issue with the chip and must be replaced.

Some people will go to their dealer when in need of a new fiat 500 remote key programming key fob, but this can be a very costly alternative. United Locksmith is the best option if you need your Fiat Replacement Key Cost keyfob fixed at a reasonable price. We have the tools and expertise to fix your fiat 500 key programming fob quickly and professionally. manner.

Faulty Receiver Module

Fiat key fobs send a signal to the vehicle which will unlock and Fiat Replacement key Cost lock doors (and start the car if it has an automatic transmission) up to 50 feet. There are many reasons why the fob may not function. This could be due to a dead battery water damage, worn-out buttons or a receiver issue signal interference, or an issue with the chip.

If the fob is in a pocket which has suffered extreme trauma (such as being dropped onto the floor or washed in the washer) the fob might not be able to communicate with the Body Control Module (BCM) of the vehicle. The BCM is a security system that will only accept signals from genuine keys.

If this is the case, you have to replace your fob. A professional locksmith is able to handle every aspect of the replacement procedure as well as programming a new one for your 500. In fact, they can even provide you with a duplicate key that functions exactly the same way as your original fob (and costs only a fraction of the cost).