Fiat 500 Replacement Key Fob

If your remote key fob isn't working, it's time to replace the battery. However, if you replace the battery but it is still not working then the issue may be elsewhere.

At United Locksmith, we specialize in making new keys for classic automobiles. We have all of the tools and accessories needed for this type of service.

Dead Coin Battery

The most frequent reason why your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The coin cell battery in the key fob will drain quickly in the event that you don't use it frequently enough. If your remote is beginning to show signs of a loss of range, or has stopped functioning in the middle of the night, then your battery may be dead.

The battery inside the key fob is held in place by metal retaining clips. If the clips aren't tight enough, they could cause contact issues that will stop your remote from receiving power. Using a small flathead screwdriver, pry the retaining clip open to take out the battery, and replace it with a brand new one. Make sure to use a battery with the same voltage, size, and specifications as the original.

The key fob could also be damaged or corroded due to exposure to water. Even a quick bath in soapy water can damage the electronic chip inside. It is recommended to keep your key fob in a dry place.

Water Damage

Water damage may be the cause of your key fob not functioning properly. The rubber seals on key fobs protect them from being damaged by a tiny drizzle or splash of water. However, it's important to keep the locked keys in car boot fiat punto of your car away from the ocean, fiat Key fob not working washing machine, and the pool.

The key fob contains an electronic chip in it that transmits a signal to your car's immobilizer system. The chip is what allows the 500 to start and lock. If it gets wet, however it will not work.

If you're trying to determine if your key fob is still functioning You can clean the internal electronics using isopropyl or an electronic cleaner. However, it is probably recommended to purchase a replacement from a dealership rather than trying to repair the key fob that is submerged in salt water.

A replacement fob may cost you a little bit however it's much less expensive than paying to have your Fiat 500 towed to a dealer and fixed there! Additionally, you can do it yourself with only a few steps. Just make sure you have the right battery type before you attempt to open your key fob. This task is much easier than it looks, and you can find step-by-step instructions online for virtually any key fob in your car.

Faulty Chip

The chip that is contained in the key fob communicates with your car's immobiliser unit to ensure the vehicle is capable of starting when the correct key is inserted. If the chip is damaged, or corrupted in any way the car won't start.

A chip that is damaged can happen due to many reasons, but the most common reason is water damage or the battery being dead. It is recommended to leave the job to a professional locksmith who can replace the chip in a short time and at a reasonable cost.

If your key fob fails to function after exposure to clean water from the tap or rain, take off the battery and clean the electronic component with a tissue to ensure it's completely dry before putting it back into. If the key fob will not function, there's a chance that it has a fried component and needs to be replaced.

Some people will go to their dealer when in need of an entirely new Fiat Key Fob Not Working key fob, but this can be a very costly alternative. If you're looking for a low-cost solution to have your Fiat key fob repaired, look no further than United Locksmith. We have the tools and knowledge necessary to fix your Fiat key fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs send a signal up to 50 feet to the vehicle, which will unlock and close the doors (and start the vehicle for vehicles with automatic transmissions). However there are a few things that could cause the fob to cease functioning. This includes a dead coin battery or water damage or worn buttons or a problem with the receiver module and signal interference, or an electronic chip that has failed.

If the fob is in a pocket which has suffered a severe trauma, like falling on hard floor or getting washed in a washing machine or dishwasher, it might not be able to communicate with the car's Body Control Module (BCM). This is because the BCM is a secure system that can only accept a signal from a genuine original key and not another.

It is necessary to replace the fob in case this occurs. A locksmith professional can handle all aspects of the replacement process and even program a new one for the 500. In fact, they can even provide you with a duplicate key that functions the same as your original fob (and costs only a fraction of the cost).